Ricoh B121 Service Manual page 463

⇒
System Switch 0A
No FUNCTION
0-3 Not used
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E
No FUNCTION
0-2 Not used
3
Action when the external
handset goes off-hook
0: Manual TX and RX operation
1: Memory TX and RX
operation (the display remains
the same)
4-7 Not used
System Switch 0F
No FUNCTION
0 Country/area code for functional
settings (Hex)
to
00: France
7
01: Germany 12: Asia
02: UK
03: Italy
04: Austria
05: Belgium
06: Denmark 17: New Zealand
07: Finland
08: Ireland
09: Norway
0A: Sweden
0B: Switz.
0C: Portugal 20: Turkey
0D: Holland
0E: Spain
0F: Israel
10: Canada
SM
Do not change the settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the settings.
Do not change the settings.
0: Manual TX and RX are possible while the
external handset is off-hook. However, memory TX
is not possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory TX operation.
Note that manual TX and RX are not possible with
this setting.
Do not change the settings.
This country/area code determines the factory
settings of bit switches and RAM addresses.
11: USA
However, it has no effect on the NCU parameter
settings and communication parameter RAM
13: Japan
addresses.
14: Hong Kong
NOTE: Please be sure to keep the following in mind
15: South Africa
16: Australia
18: Singapore
19: Malaysia
1A: China
1B: Taiwan
1C: Korea
21: Greece
Cross reference
22: Hungary
23: Czech NCU country code: SP2-103 parameter C.C.
24: Poland
COMMENTS
COMMENTS
COMMENTS
when installing the optional FAX:
After changing the Bit SW setting for the
country code (System Switch 0F), do not
use the scroll key to go to the next bit
setting. Instead, turn the main power
ON/OFF to activate the country code
setting, and then go on to the next settings.
If the scroll key is used just after the country
code is set, other bits may be changed.
25
BIT SWITCHES
Rev.09/2005
SP No. 1-101-011
SP No. 1-101-015
SP No. 1-101-016
B620