Free Run; Procedure; One-Sided Free Run Process; Two-Sided Free Run Process - Ricoh B121 Service Manual

Hide thumbs Also See for B121:

Table of Contents

2.8 FREE RUN

Two types of free runs can be performed by using Dip Switch DPS 100 on the DF

control board. The switch settings are as follows:

A: One-sided free run

B: Two-sided free run

*: When both switches have been switched to ON:

If SW 1 was turned ON first, Mode A is enabled. If SW 2 was turned ON first, Mode B

1. Turn on SW 1 or 2 (DPS 100 on DF control board).

2. Set the original on the original table.

3. After 2 seconds, the free run will automatically start.

4. To stop the free run, turn all DIP switches OFF, then turn the main power off

1. The originals are set on the original table.

2. The first page of the original is fed into the DF.

3. The sensors detect the original.

4. The original is output to the exit tray.

5. Steps 2-4 above are repeated for any additional originals set on the original

table. If there are no additional originals, the DF will stop and wait.

The process is the same, except that the original reverse cycle is added.

(*See below)

Table of Contents

B259 B260 B261 B122 B123