Ricoh B121 Service Manual page 176

SERVICE PROGRAM MODE
SP5-XXX (Mode)
5001 All Indicators On
5001 1 All LEDs turn on. The LCD turns on or off every 3 seconds. Press the reset key to
end this program.
5104* A3/DLT Double Count
5104 1 Selects whether the machine counts twice for each sheet of A3/11"x 17". If this is
set to "Yes" is selected, the total (mechanical) counter and the current user counter
will both increment by two for each A3/11" x 17" sheet.
⇒
5113* Optional Counter Type
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120* Clr-OP Count Remv
5120 1 Determines under which conditions the copy job settings are reset when the key
counter is removed. With 0, the settings are cleared if the counter is removed at the
end of a job or midway through a job. With 1, they are only cleared if the counter is
removed at the end of a job. With 2, they are not cleared at all, under either
condition. With duplex copies, the job settings are always preserved, regardless of
the setting of this SP mode.
5121* Count Up Timing
5121 1 Selects whether the key counter increments at time of paper feed-in or at time of
paper exit.
5127* APS Mode
5127 1 Enables or disables the APS mode..
5501* PM Alarm Interval (Printout)
5501 1 Specifies when the PM alarm occurs.
5801 Memory Clear
5801 2 Engine
5802 Machine Free Run
5802 1 Starts a free run of both the scanner and the printer. Press "ON" to start; press
"OFF" to stop.
B121 Series/B259 Series
[0 = Enabled / 1 = Disabled /
2 = Disabled if the size is undetected]
0: None
11: MF key card (Increment)
12: MF key card (Decrement)
NOTE: If 12 is selected duplex is not possible.
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[0 = Enabled / 1 = Disabled]
[0 ~ 9999 / 0 / 0K copies/step]
5.1.7
5-16
Rev. 6/2005
SM