Connectors Used For Servo Motor Wiring - Mitsubishi melservo-j2 series Installation Manual

3. WIRING

3 - 2 - 4 Connectors used for servo motor wiring

This section gives connector makeups on an operating environment basis. Use the models of the
manufacturers given or equivalent.
(1) HC-MF(-UE), HA-FF, HC-UF 3000r/min series
Use round crimping terminals (1.25-4) for connection of the power supply and electromagnetic brake.
For connection of the encoder, use the connector indicated in this section or equivalent. This connector
may be used with the EN Standard and UL/C-UL Standard but is not waterproof.
Servo Motor
HC-MF (B)
HC-MF (B) -UE
HA-FF (B)
HC-UF13 to 73(B)
(2) HA-FF C-UE series
If used with a waterproof connector, the HA-FF C(B)-UE does not improve in ingress protection
(IP54).
1) Non-waterproof, UL/C-UL Standard-compliant
a When using cabtyre cables
For connection of power supply
1) Plug
Servo Motor
HA-FF C(B)-UE
Servo Motor Side
Connector (AMP)
1-172169-9
2) Cable
clamp Cable
Connector Supplied for
Servo Motor
CE05-2A14S-2PD-B
Encoder Cable Connector
Housing Connector Pin
(AMP)
1-172161-9
2) Cable
1) Plug clamp
1) Plug (Daiichi Denshi Kogyo)
Type Model
Straight MS3106B14S-2S
Angle MS3108B14S-2S
3 - 15
Cable Clamp
(AMP) (Toa Denki Kogyo)
170363-1 MTI-0002
Cable
2) Cable clamp
(Daiichi Denshi Kogyo)
MS3057-6A