Table of Contents
Advertisement
SAFETY INSTRUCTIONS
1. To prevent electric shock, note the following:
Before wiring or inspection, switch power off and wait for more than 10 minutes. Then, confirm the
voltage is safe with voltage tester. Otherwise, you may get an electric shock.
Connect the servo amplifier and servo motor to ground.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and servo motor until they have been installed. Otherwise,
you may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed loaded, or pinched. Otherwise, you may get an electric
shock.
2. To prevent fire, note the following:
Do not install the servo amplifier, servo motor and regenerative brake resistor on or near
combustibles. Otherwise a fire may cause.
When the servo amplifier has become faulty, switch off the main servo amplifier power side.
Continuous flow of a large current may cause a fire.
When a regenerative brake resistor is used, use an alarm signal to switch main power off. Otherwise,
a regenerative brake transistor fault or the like may overheat the regenerative brake resistor, causing
a fire.
3. To prevent injury, note the follow
Only the voltage specified in the Installation guide should be applied to each terminal, Otherwise,
a burst, damage, etc. may occur.
Connect the terminals correctly to prevent a burst, damage, etc.
Ensure that polarity ( ,
During power-on or for some time after power-off, do not touch or close a parts(cable etc.) to the
servo amplifier heat sink, regenerative brake resistor, servo motor, etc.
Their temperatures may be high and you may get burnt or parts may damaged.
WARNING
CAUTION
CAUTION
) is correct. Otherwise, a burst, damage, etc. may occur.
2
Advertisement
Table of Contents
