Table of Contents
Advertisement
7. INSPECTION
1) Smoothing capacitor
2) Relays
3) Servo amplifier cooling fan : The cooling fan bearings reach the end of their life in 10,000 to 30,000
4) Servo motor bearings
5) Servo motor oil seal, V ring : Must be changed in 5,000 hours of operation at rated speed as a
: Affected by ripple currents, etc. and deteriorates in characteristic. The
life of the capacitor greatly depends on ambient temperature and
operating conditions. The capacitor will reach the end of its life in 10
years of continuous operation in normal air-conditioned environment.
: Their contacts will wear due to switching currents and contact faults
occur. Relays reach the end of their life at 100,000 power-on times,
which depend on the power supply capacity.
hours. Normally, therefore, the fan must be changed in a few years of
continuous operation as a guideline.
It must also be changed if unusual noise or vibration is found during
inspection.
: When the servo motor is run at rated speed under rated load, change
the bearings in 20,000 to 30,000 hours as a guideline. This differs on
the operating conditions. The bearings must also be changed if unusual
noise or vibration is found during inspection.
guideline. This differs on the operating conditions. These parts must
also be changed if oil leakage, etc. is found during inspection.
7 - 2
Advertisement
Table of Contents
