Print I/F Setting List - Ricoh C9020L Operating Instructions Manual

1. System Settings
Ping Command
Check the network connection with ping command using given IPv4 address.
If you fail to connect to the network, check the following, and then retry the ping command.
1
• Make sure that "IPv4" in [Effective Protocol] is set to [Active].
• Check that the machine with assigned IPv4 address is connected to the network.
• There is a possibility that the same IPv4 address is used for the specified equipment.
Permit SNMPv3 Communictn.
Set the encrypted communication of SNMPv3.
The default setting is [Encryption/Cleartext].
If you select to [Encryption Only], you need to set an encryption password for the machine.
Permit SSL/TLS Comm.
Set the encrypted communication of SSL/TLS.
The default setting is [Ciphertext Priority].
If you set to [Ciphertext Only], you need to install the SSL certificate for the machine.
Host Name
Specify the host name.
Enter the host name using up to 63 characters.
Machine Name
Specify the machine name.
Enter the machine name using up to 31 characters.
• p.16 "Accessing User Tools"
• p.256 "Configuring IEEE 802.1X"

Print I/F Setting List

This section describes how to print the configuration page.
You can check items related to the network environment.
The configuration page shows the current network settings and network information.
1. Press the [User Tools/Counter] key.
30