Ricoh C9020L Operating Instructions Manual page 713

If you select [Digest Authentication] or [Cleartext Authentication], proceed to step 22.
21. Select the Realm using [ ] or [ ], and then press the [OK] key.
22. Press [Com. Test].
Access the LDAP server to check that the proper connection is established. Check authentication works
according to the authentication settings.
23. Press [Exit].
24. Select [Search Conditions] using [ ] or [ ], and then press the [OK] key.
If the connection test fails, check your settings and try again.
This function does not check search conditions or the search base.
25. Select necessary search items such as [Name], [E-mail Address], [Fax Number], [Company
Name], and [Department Name] using [ ] or [ ], and then press the [OK] key.
You can enter an attribute as a typical search keyword. Using the entered attribute, the function
searches the LDAP server's Address Book.
26. Enter attribute, and then press the [OK] key.
The attribute value may change depending on the server environment. Check the attribute value
complies with your server environment before setting it.
You can leave items blank, but you cannot leave attributes blank when searching for e-mail address
from the LDAP server Address Book.
Programming the LDAP server
1
43