Sender Settings - Ricoh C9020L Operating Instructions Manual

Sender Settings

Select a user that you want to specify as a sender.
If you enable the Stamp Sender Name, the registered sender's name (user name) appears on the receiver's
sheet, lists, and report.
• You must first register the senders in the destination list using "Address Book Management" under
"System Settings", and then specify "Register as" for [Sender Only] or [Dest. & Sender]. For details
about these settings, see "Registering Addresses and Users for Facsimile Functions", Network and
System Settings Guide.
• If user authentication is set, the user logged in is set as sender.
1. Place the original, and then select the scan settings you require.
2. Press [TX Mode].
3. Select [Sender Settings] using [ ] or [ ], and then press the [OK] key.
4. Select a sender.
If a destination protection code is set, the entry screen appears. Enter the protection code for
destination using the number keys, and then press the [OK] key.
5. Confirm the selected sender, and then press the [OK] key.
Sender Settings
2
81