Ricoh C9020L Operating Instructions Manual page 835

Message
add_sess_IPX: bad trap addr: <IPX address>
community <community name>
add_sess_IPX: community <community name>
already defined.
adjust time server <NTP server name> offset: xx sec. ncsd tells you the timing of the NTP server and
ANONYMOUS FTP LOGIN FROM <IP address>,
<password>
Attach FileServer=<file server>
Attach to print queue <print queue name>
authenticating
authentication mode mismatch
child process exec error !
cipher suite mismatch
Problem and solutions
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
whether or not the time system clock is set.
NTP Server: NTP server name
offset: number of seconds of delay (minus number
if a time in advance is specified)
An anonymous user logged in from the post <IP
address> using the password <password>.
Connection to the file server as the nearest server
has been established.
The system attached to the print queue when the
print server is active.
The supplicant is authenticating with the access
point (EAP or WPA).
The authentication mode of the access point is
different from the authentication mode of the
supplicant.
Use the authentication mode between the access
point and the supplicant.
The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
The uni-cast / multi-cast suite (TKIP/AES/WEP) of
the access point is different from the suite used by
the supplicant.
Message List
4
165