Ricoh C9020L Operating Instructions Manual page 838

Table of Contents

Advertisement

4. Monitoring and Configuring the Printer
<Interface name> interface up
< Interface > started with IP: < IP address >
< Interface >: Subnet overlap.
job canceled. jobid=%d.
4
Lease Time=<lease time>(sec),
RenewTime=<renew time>(sec).
LEAP challenge to access point failed
Login to fileserver <file server name> (<IPX|IP>),
<NDS|BINDERY>
Memory allocate error.
MIC failure TKIP counter measures started
MIC failure TKIP counter measures stopped
Name registration failed. name=<NetBIOS name> Name registration of <NetBIOS Name> failed.
Name registration success in Broadcast
name=<NetBIOS name>
Name registration success. WINS server=<WINS
server address> NetBIOS Name=<NetBIOS
name>
no RADIUS/authentication server
168
Message
Problem and solutions
The interface managed by the supplicant is
enabled, or is connected to the access point.
IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
The same IP address (IPv4, orIPv6 address) and the
subnet mask is used with other device.
The spooled job was canceled due to error or user
request.
The resource lease received from the DHCP server
is displayed in [lease time] in seconds. The renewal
time is displayed in [renew time] in seconds.
The LEAP challenge to the access point has failed.
When the print server is active, the system logged
in to <file server> in the NDS or BINDERY mode.
The transfer protocol in use is also displayed.
Date cannot be obtained. Disconnect the USB
cable, and then connect it.
The supplicant using TKIP has detected two
instances of tampering within 60 seconds and has
started counter measures.
Counter measures have stopped after 60 seconds
(since the supplicant using TKIP started counter
measures against tampering).
Change to different NetBIOS name.
Name registration by Broadcast name of
<NetBIOS Name> was successful.
Name registration of <NetBIOS Name> to <WINS
server address> was successful.
The supplicant has received a message reporting
that a usable RADIUS server cannot be found.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ld520clMp c2030

Table of Contents