Primary Drive Gear - Honda 1998 VT750C Service Manual

CLUTCH/GEARSHIFT LINKAGE
INSTALLATION
Install the new
Press the new needle bearing into the clutch outer
needle bearing
so that the needle bearing outer surface is 1.0 mm
with the mark
(0.03 in). below the outer edge of the clutch outer
facing out.
needle bearing cavity.
TOOLS:
Driver
Attachment, 37 X 40 mm
Pilot,30 mm
07749-0010000
077 46-00 10200
07746-0040700
ATIACHMENT
PRIMARY DRIVE GEAR
REMOVAL
Remove the clutch (page 8-4).
Remove the ignition pulse generator mounting bolts.
Remove the ignition pulse generator and grommets.
Temporarily install the clutch outer onto the main-
shaft (page 8-18).
Hold the primary drive gear with the gear holder and
remove the primary drive gear bolt and washer.
TOOL:
Gear holder
07724-0010100
Remove the clutch outer and gear holder (page 8-6).
Remove the ignition pulse generator rotor.
Be careful not
Remove the primary drive gear as assembly.
to loose the
disassembled
parts.
8-10
IGNITION PULSE GENERATOR
ROTOR
'<:'"