Torque Values; Engine - Honda 1998 VT750C Service Manual

GENERAL INFORMATION
TORQUE VALUES
FASTENER TYPE
TORQUE
FASTENER TYPE
TORQUE
N·m (kgf·m, Ibf·ft)
N·m (kgf·m, Ibf·ft)
5 mm hex bolt and nut
5 (0.5, 3.6) 5 mm screw
4 (0.4, 2.9)
6 mm hex bolt and nut 10 (1.0,7) 6 mm screw 9 (0.9, 6.5)
8 mm hex bolt and nut 22 (2.2,16) 6 mm flange bolt (8 mm head) 9 (0.9, 6.5)
10 mm hex bolt and nut
34 (3.5,25)
6 mm flange bolt (10 mm head) and nut 12 (1.2,9)
12 mm hex bolt and nut
54 (5.5, 40)
8 mm flange bolt and nut 26 (2.7, 20)
10 mm flange bolt and nut 39 (4.0, 29)
• Torque specificatons listed below are for important fasteners .
• Others should be tightened to standard torque values listed above.
NOTES: 1. Apply sealant to the threads.
2. Apply a locking agent to the threads.
3. Apply grease to the threads.
4. Stake.
5. Apply oil to the threads and flange surface.
6. Apply oil to the threads and a-ring.
7. U-nut.
8. ALOC bolt: replace with a new one.
9. Left hand threads
10. CT bolt
11. CT bolt (one-side only)
ENGINE
.....
ITEM
Q'TY
THREAD TORQUE
REMARKS
DIA.(mm) N·m (kgf·m, Ibf·ft)
MAINTENANCE:
Spark plug 4 12 14 (1.4,10)
Crankshaft hole cap 1 22 15 (1.5, 11) NOTE 3
Timing hole cap 1 30 15 (1.5, 11) NOTE 3
Valve adjusting screw lock nut 6 7 23 (2.3, 17) NOTE 5
Oil drain bolt 1 14 30 (3.1, 22)
Oil filter cartridge 1 20 10 (1.0,7) NOTE 6
Vacuum plug 2 5 3 (0.3, 2.2)
LUBRICATION SYSTEM:
Oil pressure switch 1 PT1/8 12 (1.2,9) NOTE 1
Oil pressure switch cord terminal screw 1 4
2 (0.2, 1.4)
Oil pump cover bolt 3 6
13 (1.3, 9)
NOTE 10
COOLING SYSTEM:
Water pump cover bolt 3 6
13 (1.3, 9)
NOTE 10
CLUTCH/GEARSHIFT LINKAGE:
Clutch lifter plate bolt 4 6 12 (1.2, 9)
Clutch center lock nut 1 18 128 (13.0, 94) NOTE 4, 5
Primary drive gear bolt 1 12 88 (9.0, 65) NOTE 5
Gearshift return spring pin 1 8 23 (2.3, 17)
Oil pump driven sprocket bolt 1 6 15 (1.5,11) NOTE 2
ENGINE MOUNTING:
Left rear cover bolt 1 6 12 (1.2,9)
Drive sprocket bolt 2 6 10 (1.0, 7)
Drive chain guide plate bolt 2 6
12 (1.2,9)
NOTE 11
1-13