Mainshaft - Honda 1998 VT750C Service Manual

MAINSHAFT
CRANKSHAFT/TRANSMISSION
ASSEMBLY
Clean all parts in solvent.
Apply molybdenum oil solution to the transmission
gear shift fork groove, transmission collar inner and
outer surface and spline collar outer surface to ensure
initial lubrication.
Assemble all parts into their original positions.
NOTE:
• Check the gears for freedom of movement or
rotatioll on the shaft.
• Install the washers and snap rings with the
chamfered edges facing the thrust load side.
• Do not reuse worn snap rings which could easily
spin in the grooves.
• Check that the snap rings are seated in the
grooves. Align their end gaps with the grooves
ofthe spline.
M5 GEAR (24T)
SPLINE BUSHING
SPLINE WASHER
/
MAINSHAFT/M1 GEAR (12T)
M4 GEAR
123:~T
RINGj'NE WASHER
00
M3 BUSHING
12-17