Shock Absorber - Honda 1998 VT750C Service Manual

REAR WHEEL/BRAKE/SUSPENSION
Apply grease to the middle rod joint bolt sliding area.
Install the middle rod joint with the washer and joint
bolt.
Tighten the bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 Ibf·ft)
Connect the brake rod to the brake arm.
Install the muffler (page 2-8).
Adjust the brake pedal free play (page 3-24).
SHOCK ABSORBER
REMOVAL
Raise and support the motorcycle using a hoist or
jack under the engine.
Remove the upper and lower mounting bolts and
washers.
Remove the shock absorber.
INSPECTION
Visually inspect the shock absorber for damage.
check the following:
- Damper unit for deformation or oil leaks
- Upper and lower joint bushings for wear or damage
Check smooth damper operation.
CAUTION:
Do not disassemble the shock absorber. Replace the
shock absorber if any component is damaged.
14-18