Regulator/Rectifier; Wire Harness Inspection; Battery Line; Charging Line - Honda 1998 VT750C Service Manual

REGULATOR/RECTIFIER
WIRE HARNESS INSPECTION
Remove the left side cover (page 2-4).
Disconnect the regulator/rectifier 6P connector.
Check the connectors for loose or corroded terminals.
BATTERY LINE
Make sure the battery voltage between RedlWhite
(+)
and Green (-).
If there are no voltage, measure the following:
Item Terminals
Specification
Battery RedlWhite
(+)
Battery voltage
charging and
line
ground (-)
should register
Green and
Continuity exists
Ground line
ground
BATTERY/CHARGING SYSTEM
It is not necessary
to remove the stator
coil to complete this
test.
CHARGING LINE
Measure the resistance between the connector
terminals and ground.
CONNECTION: Yellow and Yellow
STANDARD: 0.1 - 0.3
n
(20 'C/68 'F)
If
the charging coil reading is out of specification,
replace the stator (page 9-2).
Check for continuity between the connector
terminals and ground.
Th.ere should be no continuity.
If the there is continuity between the connector and
ground, replace the stator (page 9-2).
\
16-9