Wheel; Wheel Bearing; Driven Sprocket - Honda 1998 VT750C Service Manual

REAR WHEEL/BRAKE/SUSPENSION
WHEEL
Check the rim runout by placing the wheel in a turn-
ing stand.
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS: Radial: 2.0 mm (0.08 in)
Axial: 2.0 mm (0.08 in)
WHEEL BEARING
Turn the inner race of each bearing with your finger.
Bearings should turn smoothly and quietly. Also
check that the bearing outer race fits tightly in the
hub.
Replace the
Remove and discard the bearings ifthe races do not
wheel bearings in
turn smoothly and quietly, or if they fit loosely in
pairs.
the hub.
WHEEL BEARING
DRIVEN SPROCKET
Check the condition of the final driven sprocket teeth.
Replace the sprocket if worn or damaged.
OK
NO GOOD
NOTE:
If the final driven sprocket requires replacement,
inspect the drive chain and drive sprocket.
• Never install a new drive chain on a worn sprocket
or a worn chain on new sprockets. Both chain and
sprocket must be in good condition or the
replacement chain or sprocket will wear rapidly.
DISASSEMBLY
Remove the brake panel assembly from the right
wheel hub.
14-4
o
X
~~