Flywheel Installation - Honda 1998 VT750C Service Manual

ALTERNATOR/STARTER CLUTCH
TORQUE: 29 N·m (3.0 kgf·m, 22 Ibf·ft)
Hold the flywheel using the flywheel holder.
Clean and apply a locking agent to the starter one-
way clutch torx bolt threads.
Install and tighten the starter one-way clutch torx
bolts to the specified torque.
- ,_ FLYWHEEL
.
-
1&
BOLTS
07925-0040000 or
equivalent commercially
available in U.S.A.
TOOL:
Flywheel holder
Install the starter driven gear to the flywheel while
turning the driven gear counterclockwise.
FLYWHEEL INSTALLATION
During woodruff
Apply engine oil to the needle bearing and install it
key installation,
to the crankshaft.
be careful not to
Wipe any oil off the mating surface of the crankshaft.
damage the key
Install the woodruff key to the key groove of crank-
groove or
shaft.
crankshaft.
Wipe any oil off the mating surface of the flywheel.
Install the flywheel to the crankshaft aligning the key
groove of the flywheel with the woodruff key on the
crankshaft.
9-7