Thermostat - Honda 1998 VT750C Service Manual

COOLING SYSTEM
Install the reserve tank (page 6-18).
Fill the system with the recommended coolant
through the filler opening up to filler neck.
Remove the reserve tank cap and fill the reserve tank
to the upper level line.
Bleed air from the system as follows:
1. Shift the transmission into neutral.
Start the engine and let it idle for 2 - 3 minutes.
2. Snap the throttle 3 - 4 times to bleed air from
the system.
3. Stop the engine and add coolant up to the filler.
neck. Reinstall the radiator cap.
4. Check the level of coolant in the reserve tank
and fill to the upper level if it is low.
THERMOSTAT
REMOVAL
Remove the following:
- Fuel tank (page 2-4)
- Steering covers (page 2-3)
Drain the coolant (page 6-5).
Remove the radiator filler mounting bolts.
Remove the thermostat housing cover bolts and
cover.
Remove the a-ring and thermostat from the
housing.
NOTE:
The thermo switch, may be damaged if dropped or
shocked. If dropped or shocked, inspect the thermo
switch and replace if necessary (page 19-21).
Thermo switch inspection and removal (page 19-
22).
Coolant temperature indicator inspection (page 19-
21).
6-6