Cylinder Head Removal - Honda 1998 VT750C Service Manual

CYLINDER HEAD/VALVES
CYLINDER HEAD REMOVAL
NOTE:
• The engine must be removed from the frame
before servicing the rear cylinder head.
• The front cylinder head and rear cylinder head
cover can be serviced with the engine in the
frame.
• The rear cylinder head service using the same
procedure as for the front cylinder head.
Remove the engine from the frame (rear cylinder
only/Section 7).
Remove the cylinder head cover (page 10-5).
Remove the camshaft (page 10-8).
Remove the cam chain tensioner mounting bolts and
sealing washers.
Remove the cam chain tensioner.
Remove the cushion rubber.
Loosen the bolts
Remove the following cylinder head bolts and nuts:
and nuts in
a - 8 mm bolts/washers
crisscross pattern -
6 mm bolt
in several times. -
10 mm nuts/washers
Be careful not to
Remove the cylinder head.
damage the
mating surfaces
when removing
the cylinder head.
Remove the gasket and dowel pins.
10-14
CAM CHAIN TENSIONER
',I
~_,';a