Clutch Installation - Honda 1998 VT750C Service Manual

CLUTCH/GEARSHIFT LINKAGE
CLUTCH INSTALLATION
Install the oil
pump drive
sprocket with its
boss side facing
out.
NOTE:
If the oil pump driven sprocket is removed, tighten
the driven sprocket bolt to the specified torque
after clutch installation.
Apply molybdenum disulfide oil to the clutch outer
guide outer surface.
Install the clutch outer guide to the mainshaft.
Install the oil pump drive sprocket to the clutch outer
guide.
Install the oil pump drive chain to the oil pump drive
and driven sprocket.
Install the oil pump driven sprocket with the "IN"
mark on the driven sprocket facing inside.
)
Align the flat surfaces of the driven sprocket hole and
oil pump shaft end.
"
-,---
.~::;;;;:;~~~iiiiiiiiia:::::IL:W
S PROCKET SOLT
NOTE:
Clean and apply a locking agent to the oil pump dri-
ven sprocket bolt threads.
Install the oil pump driven sprocket bolt.
If the oil pump driven sprocket is removed, tighten
the driven sprocket bolt to the specified torque
after clutch installation.
I
8-17