Oil Pressure Switch; Brake Light Switch Check - Honda 1985 CBX750F Workshop Manual

HONDA
CBX750F
SWITCHES
OIL
\
PRESSURE SWITCH
Remove the engine (Section 5).
Pull the rubber cover off the oil pressure switch.
Disconnect the oil pressure switch lead and remove
the switch.
Check for continuity while applying pressure to the
switch.
No continuity: Above 20-40 kPa
(0.2-0.4 kg/cm
2
,
2.8-5.7 psi)
Replace the switch if necessary.
Apply a liquid sealant to the switch threads before
installing the switch.
Screw the switch into the crankcase but stop two
threads from the bottom. Then tighten it to the
(1) 01 L PRESSURE SWITCH
specified torque.
TORQUE: 15-20 N·m
(1.5-2.0
kg·m,
11-14 ft-Ib)
NOTE:
To prevent crankcase damage. do not over­
tighten the switch.
BRAKE LIGHT SWITCH
Remove the right frame side cover and disconnect
the rear brake switch wire coupler.
Check the rear brake light switch for continuity
with the rear brake applied.
(1)
REAR BRAKE LIGHT SWITCH WIRE
(1)
FRONT
BRAKE LIGHT SWITCH
Check the front brake light switch for continuity
with the front brake applied.
Replace the switches if necessary.
19-2