Pilot Screw Removal; Pilot Screw Installation; Carburetor Installation - Honda 1985 CBX750F Workshop Manual

HONDA
CBX750F
FUEL SYSTEM
--..
PILOT SCREW
REMOVAL
NOTE:
The pilot screws are factory pre-set and
should not be removed unless the carburetors
are overhauled.
Turn each pilot screw in and carefu lIy count the
number of turns before it seats lightly.
Make a note of this to use as a reference when re­
installing the pilot screws.
CAUTION
Damage to the pilot screw seat will occur if
the pilot screw is tightened against the seat.
Remove the pilot screws and inspect them. Replace
they are worn or damaged.
~NS\ALLA\ION
Install the pilot screws and return them to their
original position as noted d.uring removal.
Perform pilot screw adjustment if a new pilot screw
is installed (page 4·14).
NOTE:
(1) PILOT SCREWS
If you replace the pilot screw in one carbure­
tor, you must replace the pilot screws in the
other carburetors for proper pilot screw ad ­
justment.
CARBURETOR INSTALLATION
Installation is essentially the reverse of removal.
NOTE :
Route the throttle and choke cables properly
(page 1-8).
Perform the following inspections and adjustments.
• Throttle operation (page 3·5).
• Carburetor choke (page 3-6).
• Carburetor idle speed (page 3·9).
• Carburetor synchronization (page 3-8).
4-13