Table of Contents
Advertisement
~HONDA
~
CBX750F
REAR WHEEL/SUSPENSION
\
INSPECTION
Remove the collars.
Check the bushing and needle bearings for wear or
damage.
Check the dust seals for damage.
Replace the dust seal if necessary.
NOTE:
The bushing and needle bearings cannot be
replaced. If they are damaged or worn, reo
place the shock link and/or
shock
arm.
INSTALLATION
Apply molybdenum disulfied grease to the needle
bearings and dust seal lips.
Install the shock arm to the frame and tighten the
(1)
SHOCK ARM
(2) SHOCK LINK
mounting nut.
TORQUE: 40-50 N·m
(4.0-5.0 kg·m, 29-36 ft·lb)
-
. _ "
Install the shock link to the swingarm and tighten
the mount nut.
TORQUE: 40-50 N'm
(4.0-5.0 kg·m, 29-36 ft-Ib)
Connect the shock link to the shock absorber and
tighten the lower mounting nut.
TORQUE: 40-50 N·m
(4.0-5.0 kg·m, 29-36 ft·lb)
Connect the shock arm to the shock link and tight·
en the nut.
(l) EXHAUST CHAMBER-TO-ENGINE BOLTS
TORQUE: 40-50 N·m
(4.0-5.0 kg·m, 29-36 ft·lb)
Install the muffler.
Tighten the exhaust charnber-to-enqlne bolts.
TORQUE: 45-60 N·m
(4.5-6.0 kg·m, 33-43 ft·lb)
14-15
Advertisement
Table of Contents
Troubleshooting
