HONDA
CBX750F
HYDRAULIC BRAKES
,
CYLINDER INSPECTION
Check the caliper cylinder for scoring, scratches or
other damage. Measure the caliper cylinder bore.
SERVICE LIMIT:
FRONT: 32.09 mm (1.263 in)
REAR:
30.29 mm (1.193 in)
ASSEMBLY
(1)
12i PISTON AND DUST SEALS
/
/
If the pivot collar boots are hardened or deterio
rated, replace them with new ones.
The piston and dust seals must be replaced with new
ones whenever they are r.e!'ll<!vec:!. C()at.the
~eal~__
_
_
-.Ii
with silicone grease or brake flu id before assembly.
Install the pistons with the dished ends toward the
pads.
..\ r>. ~
Apply silicone grease to the pivot collar and boots
(\,~.~i:_
' . "
and install the collar and boots making sure that the
boots are seated in the collar and caliper grooves
".+" . :
.'-~
.:
~~
- .
I.
properly.
Install the pad spring.
~
Install the pads (page 15·5).
I
/
\'~'/~
(3) PAD SPRING (4) PIVOT COLLAR
(S) PISTONS
INSTALLATION
(1) FRONT
(2) BOOT
(3) REAR
Make sure that the retainer clip is in position on the
caliper bracket.
Inspect the condition of the caliper pin bolt boot.
Apply silicone grease to the caliper pin bolt boot
and bolt.
I
(4) RETAINER CLIP
(4) RETAINER CLIP
15-13