HONDA
CBX750F
REAR WHEEl/SUSPENSION
(1) LOCK NUT
(2) AXLE NUT
REAR WHEEL
REMOVAL
Place the motorcycle on its center stand.
Loosen the drive chain adjuster lock nuts and ad
justing nuts.
Remove the axle nut and axle.
Push the wheel forward, remove the drive chain
from the driven sprocket and remove the rear wheel.
NOTE:
If you depress the brake pedal after the rear
wheel is removed, the caliper piston will move
out and make reassembly difficult.
(3) ADJUSTING NUT
-
INSPECTION
AXLE
Set the axle in
V
blocks and read the axle runout
with a dial indicator.
SERVICE LIMIT: 0.2 mm (0.01 in)
REAR WHEEL RIM RUNOUT
Check the rim for runout by placing the wheel in a
truing stand. Spin the wheel slowly, and read the
runout using a dial indicator.
SERVICE LIMITS:
RADIAL RUNOUT: 2.0 mm (0.08 in)
AXIAL RUNOUT:
2.0 mm (0.08 in)
NOTE:
The wheel cannot be serviced and must be
replaced if the above limits are exceeded
.
14-3