Clutch Master Cylinder Disassembly - Honda 1985 CBX750F Workshop Manual

HONDA
CBX750F
CLUTCH
1) Squeeze the clutch lever, open the bleed valve
1/2
turn then close the valve.
NOTE:
Do not release the clutch lever unt il the bleed
valve has been closed again.
2)
Release the clutch lever slowly and wait seve ral
seconds after it reaches the end of its
travel .
Repeat the above steps until bubbles cease to appe ar
in the fluid at the end of the hose.
Fill the flu id reservoir to the upper level.
CLUTCH MASTER CYLINDER
DISASSEMBLY
Drain clutch fluid from the hydraulic system.
--- - Remove the rear view mirror and clutch lever.
Disconnect the clutch switch wires and remove th e
clutch hose .
CAUTION
Avoid spilling clutch fluid on painted surfaces.
Place a rag over the fuel tank whenever the
clutch system is serviced.
NOTE :
. - - - - - - - - - - - - - - - - - - - - - -- - - ,
When removing the oil bolt, cover the end of
I
the hose to prevent contamination and secure
the hose.
Remove the master cylinder.
Remove the push rod, boot, and snap ring from the
master cylinder body.
8-4
(1) BLEED VALVE
(2 ) B LE ED HOS E
(1)
OIL BOLT
(1) SNAP RING PLIERS
07914-3230001 ~