Set The Scsi Id Number For Removable Media Drives - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

>>cnfg 3
3: KN02-BA DEC
---------------------------------------------------
DEV
===== ================== ========= ====== ========
tz1
rz2
dcache ( 64 KB), icache ( 64 KB)
mem( 0):
mem( 1):
mem( 2):
mem( 3):
mem( 4):
mem( 5):
Write down any device codes that are displayed in the
3.
column on your screen. In this example, we would write
down
Turn off the system unit by pressing 0 on the on/off switch
4.
on the back of the unit.
Remove the cover from the system unit, as shown in
5.
Figure 5-1, on page 5-3.
Place the loop of the antistatic strap around your wrist and
6.
clip the other end of the strap to the metal frame of the
system unit.
Unpack the removable media drive that you are installing.
7.
Figure D-5, on page D-6, shows an RX23 disk drive and
SCSI switch settings.

Set the SCSI ID number for removable media drives

Choose a SCSI ID number for the drive. Follow these
1.
steps:
V5.7e
PID
RZ23 (C) DEC
a0000000:a03fffff
a0400000:a07fffff
a0800000:a0bfffff
a0c00000:a0ffffff
a1000000:a13fffff
a1400000:a17fffff
and .
rz2 tz1
Read the device codes that you wrote down in step 4.
In the example, we wrote
Choose any number from 0 to 6 that is not already used
in the device codes displayed on the screen in the
column. In this example, we can choose 0, 3, 4, 5, or 6
because the numbers in the device codes are 1 and 2.
In this example, assume that we chose 4.
TCF0 ( 24 MB)
(enet: 08-00-2b-0f-45-72)
(SCSI = 7)
VID
DEC
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
and
rz2 tz1.
Internal Hardware Options 5–43
REV SCSI DEV
SEQ
0700 DIR
DEV
DEV