Close The System Unit - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Repeat steps 1 to 5 to install another memory module in
6.
the other empty connector of the same slot.
Repeat the installation for every pair of memory modules
that you are installing. Be sure to install each pair of
modules in the slot with the lowest number.

Close the system unit

Insert the tabs on the front drive panel into the cutouts on
1.
the system unit and tilt the panel halfway down into the
system unit.
If you disconnected cables from a drive in the drive bracket,
2.
hold the panel while you pass the loose ends of the cables
through the large cutout in the end of the drive bracket.
Plug the ends of the cables into the connectors on the drive.
If there is no drive in the drive bracket, pass the cables
through the large cutout and tuck the ends of the cables
into the bracket.
Carefully lower the end of the bracket onto the two posts
3.
that support it.
If you cannot seat the drive bracket on the two posts, lift
the end of the bracket and rearrange the cables. Then
lower the bracket again.
Internal Hardware Options 5–11