Close The System Unit; Inserting A Removable Media Drive Into The Drive Bracket - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Pull up carefully on the end of the drive bracket. If the
6.
power supply and SCSI cables are threaded through the
cutout in the end of the drive bracket, ease them through
the cutout as you pull up, as shown in Figure 5-4, on
page 5-6.
Carefully remove the front drive panel from the system
7.
unit. Set it next to the system unit.
Slide the removable media drive that you are installing into
8.
the drive bracket from the front of the front drive panel.
Figure 5-25. Inserting a removable media drive into the drive bracket
Use a flat-blade screwdriver to tighten the screws on both
9.
sides of the drive bracket. There are two screws on each
side. You may have to push the screws in first, so that they
fit into the threaded holes in the drive.

Close the system unit

Insert the tabs on the bottom edge of the front drive panel,
1.
as shown in Figure 5-4, on page 5-6, into the cutouts in the
bottom of the system unit.
Lower the end of the drive bracket far enough to thread the
2.
power supply and SCSI cables through the large cutout in
the drive bracket.
Hold the drive bracket with one hand as you thread the
cables through the cutout with your other hand.
5–46 Internal Hardware Options
RX23 drive
Captive
screws
WS33O059