To Test For A Drive In The Front Drive Panel - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

To Test for a Drive in the Front Drive Panel

At the console prompt (
1.
The screen shows the detailed configuration (or list of
components in your system unit, or base slot 3). The
display should list the drive that you installed along with
the SCSI number that you gave it. Here is an example
display:
>cnfg 3
3: KN02-BA DEC
---------------------------------------------------
DEV
===== ================== ========= ====== ========
tz1
rz2
rz4
dcache
mem( 0):
mem( 1):
mem( 2):
mem( 3):
mem( 4):
mem( 5):
In this example, the new drive is an RX23 floppy disk drive.
We gave it a SCSI ID number of 4. This number, in this
case,
internal hard disk drive (
connected to system unit are also shown.
If the new drive is not listed at all,
Open the system unit and check for these two possibilities.
Then use the cnfg command to test the drive again. If
your new drive is still not listed properly, tell your system
manager or call your Digital Customer Support Center.
5–52 Internal Hardware Options
V5.7e
PID
RZ55 (C) DEC
RX23 (C) DEC
( 64 KB), icache ( 64 KB)
a0000000:a03fffff
a0400000:a07fffff
a0800000:a0bfffff
a0c00000:a0ffffff
a1000000:a13fffff
a1400000:a17fffff
, is listed in the
rz4
The cables to the drive may not be plugged in all the
way.
You may have set a SCSI ID number that was already
set on another drive inside the system unit.
), type cnfg 3 and press Return.
>>
TCF0 ( 24 MB)
(enet: 08-00-2b-0f-45-72)
(SCSI = 7)
VID
DEC
DEC
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
( 4 MB)
column. The tape drive and
DEV
and ) that were already
tz1 rz2
REV SCSI DEV
SEQ
0700 DIR
0700 DIR