Removing The Front Drive Panel - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Loosen the two screws that hold the front drive panel in
7.
place. They are captive screws and cannot be removed.
Unhook the power supply cable from the white loop on the
8.
end of the drive bracket on the front drive panel and loosen
the two captive screws on the end of the bracket.
Pull up carefully on the end of the drive bracket. As you
9.
raise the end of the bracket, be sure not to damage any
SCSI and power supply cables that pass through the cutout
in the end of the bracket.
Set the front drive panel aside. Handle it carefully if a
drive is in the bracket.
Captive screw
Front drive panel
WS33O107
Figure 5-4. Removing the front drive panel
5–6 Internal Hardware Options
Power supply cable
SCSI cable
This is one of five tabs.
Captive screw
Captive screw