Close The System Unit - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

The drive should rest flat in the system unit, and the
locking post should stick up through the mounting hole on
the drive mounting bracket.
Press the sliding latch so that it snaps firmly onto the post.
14.
If you are installing two hard disk drives, insert the tabs on
15.
the second drive into the system unit cutouts and lock the
drive onto the mounting post.
Press all the cables carefully around the hard disk drive or
16.
drives, so that there is room for the drive bracket on the
front drive panel.

Close the system unit

Insert the tabs on the front drive panel into the system unit
1.
cutouts and tilt the panel halfway down into the system
unit, as shown in Figure 5-17, on page 5-32.
Hold the panel while you thread the loose ends of the power
2.
supply cable and SCSI cable through the large cutout in the
end of the drive bracket.
If there is no drive, tuck the ends of the cables into the
bracket.
Carefully lower the end of the bracket onto the two posts
3.
that support it. Make sure that the cables have been
correctly pressed around the internal hard disk drive or
drives. If this is not done properly, the bracket cannot be
seated.
Tighten the two captive screws on the end of the bracket
4.
until they are at least finger tight.
Tighten the two captive screws that hold the front drive
5.
panel on the system unit until they are at least finger tight.
Remove the antistatic wrist strap from your wrist and from
6.
the system unit.
Standing at the front of the system unit, position the
7.
cover slightly above the system unit about 2 inches
(5.5 centimeters) from the back of the unit.
Rest the cover on the system unit. Then slide it all the way
8.
to the back of the unit.
Internal Hardware Options 5–39