System Unit; To Install A Removable Media Drive Inside The System Unit; Unpack The Removable Media Drive - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Insert the tabs on the front drive panel into the cutouts on
13.
the system unit.
Thread the loose ends of the power supply cable and SCSI
14.
cable through the large cutout in the bracket.
If a drive is in the bracket, make sure the ends of the
cables are correctly plugged into the connectors on the
drive. If there is no drive, tuck the ends of the cables into
the bracket.
Carefully lower the end of the bracket onto the two posts
15.
that hold the bracket.
Tighten the two captive screws on the end of the bracket
16.
until they are at least finger tight.
Tighten the two captive screws that hold the front drive
17.
panel on the system unit until they are at least finger tight.
Remove the antistatic wrist strap.
18.
Replace the cover on the system unit, as shown in
19.
Figure 5-1, on page 5-3.
Turn on the system unit and monitor and check the
20.
workstation with the cnfg command.

To Install a Removable Media Drive Inside the System Unit

To install a removable media drive in the front drive panel, you
need medium flat-blade and Phillips screwdrivers, and you may
need small needle-nose pliers.

Unpack the removable media drive

Follow the instructions that came with your worksystem
1.
software to shut down the software.
Type cnfg 3 and press Return. The workstation displays
2.
the configuration for the system unit, which is called base
slot 3. Internal disk drives are connected to base slot 3.
Here is an example configuration display. It shows one
internal hard disk drive
(tz1)
on the monitor screen in the
5–42 Internal Hardware Options
connected to base slot 3. This information appears
and one internal tape drive
(rz2)
column.
DEV