To Test Memory Modules - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Rest the cover on the system unit. Then slide it all the
8.
way to the back of the unit, as shown in Figure 5-11, on
page 5-18.
Press the cover-release screw on the back of the unit and
9.
tighten it.

To Test Memory Modules

Turn on the monitor. Then turn on the system unit.
1.
When the system unit completes the power-up self-test
successfully, the console prompt (
Type t 3/mem followed by a space and the number of the
2.
memory slot into which you installed the modules. Then
press Return. For example, to test the modules in memory
slot 2, type t 3/mem 2.
A display similar to the following appears on your screen as
the memory test progresses:
**\
When the test is done, the console prompt (
something other than the console prompt appears, turn to
Chapter 10 for troubleshooting instructions.
Use the t 3/mem command to test the rest of the memory
3.
slots in which you installed memory modules.
Type cnfg at the console prompt and press Return to see
4.
the total amount of memory in the workstation. A display
like the following appears on your screen:
>>cnfg
3: KN02-BA DEC
This example shows a workstation with 24 megabytes
(24 MB)
The display should show the total amount of memory in
your workstation. If it does not, turn to Chapter 10 for
troubleshooting instructions.
V5.7e TCF0
of memory.
) appears on the screen.
>>
>>
( 24 MB)
(enet: 08-00-2b-0f-45-72)
(SCSI = 7)
Internal Hardware Options 5–13
) appears. If