Interactive Exhaust Harness (Xb12 Models) - Buell 2007 FIREBOLT Service Manual

HOME

INTERACTIVE EXHAUST HARNESS (XB12 MODELS)

REMOVAL
1. Remove seat and pillion. See
2. Remove intake cover assembly. See
COVER ASSEMBLY.
3. Remove negative battery cable from battery.
4. Remove main battery ground and the exhaust actuator
ground.
5. Remove the subframe tail body work. See
FRAME TAIL ASSEMBLY AND BODY
6. See Figure 7-84. Separate exhaust actuator harness
connector [165] (2) at main harness.
7. Note location of cable strap and cut as required.
8. Pull actuator harness through frame.
9. Disconnect connector [161B] from actuator.
NOTE
For actuator and actuator cable replacement see
ACTIVE EXHAUST SYSTEM (XB12
7-68 2007 Buell Firebolt: Electrical
2.38 SEAT.
2.34 INTAKE
2.36 SUB-
WORK.
7.6 INTER-
MODEL).
8463
3
1
2
1. Fuel vent hose
2. Main wire harness
3. Cable strap
4. Rear shock reservoir hose
5. Main wire harness connection [165]
Figure 7-84. Left Side Subframe Hose and Wire Routing
8478
1
2
3
1. Main battery ground
2. Wire harness ground
3. Main fuse case
Figure 2-85. Battery and Harness Ground
(battery removed for clarity)
7.24
5
4