Buell 2007 FIREBOLT Service Manual page 328

HOME
8760
Figure 3-138. Removing Sprocket Shaft Inner Bearing
Race
3. See Figure 3-138. Place flywheel assembly in FLY-
WHEEL SUPPORT FIXTURE (Part No. HD-44385). Pull
sprocket shaft bearing inner race with WEDGE ATTACH-
MENT for CLAW PULLER (Part No. HD-95637-46A) with
BEARING RACE REMOVER/INSTALLER (Part No. HD-
34902B) and END CAP (Part No. HD-34902-7).
NOTE
Sprocket shaft bearing inner race does not need to be
ground once it is installed on the sprocket shaft.
It is necessary to remove the stator replace the sprocket
shaft bearing or seal. See
8861
Figure 3-139. Sprocket Shaft Seal Retaining Ring
4. See Figure 3-139. Remove sprocket shaft oil seal retain-
ing ring.
5. See Figure 3-137. Remove sprocket shaft oil seal (3)
from crankcase using Snap-On Tool (Part No. CJ 114,
Body Dent Puller)
6. Remove outer thrust washer (4) next to sprocket shaft
bearing (6).
7.8 ALTERNATOR.
8762
Figure 3-140. Removing Sprocket Shaft Bearing
Retaining Ring
7. See Figure 3-140. Remove sprocket shaft bearing retain-
ing ring from the inside of the left crankcase half.
8790
Figure 3-141. Direction of Bearing Removal
From Left Crankcase
8. See Figure 3-141. Using CRANKCASE BEARING
REMOVER/INSTALLER with ADAPTER (Part No. B-
45655, HD-42720-2 and HD-46663) press sprocket shaft
bearing out of the left crankcase half.
NOTE
The bearing presses to the inside. There is a shoulder incor-
porated into the left crankcase half which allows the bearing
to be removed in one direction only.
2007 Buell Firebolt: Engine 3-97