Instrument Module - Buell 2007 FIREBOLT Service Manual

HOME

INSTRUMENT MODULE

GENERAL
Replace the instrument module if the unit is not working prop-
erly. However, before replacing a component, check that the
problem is not caused by a loose wire connection.
NOTE
Replacement bulbs are available for indicator, check
engine light and backlights.
Replace instrument module if low fuel warning indicator
fails.
8444
Figure 7-61. Instrument Module
REMOVAL
1. Remove seat. See 2.38
1 1
WARNING WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative battery cable.
3. Remove headlight support bracket. See
LIGHT ASSEMBLY AND SUPPORT
4. See Figure 7-64. Disconnect instrument module connec-
tor [39].
5. See Figure 7-65. Remove fasteners (5) and washers (4).
6. Pull instrument module (2) from headlight support
bracket (1).
Bulb Replacement
1. Once the instrument module has been removed from the
vehicle place face down on a work surface.
2. Remove the nine fasteners securing the back of the
module housing to the display and remove back cover.
NOTE
Do not turn display over. Speedometer and Tachometer will
fall out possibly causing damage to instruments.
7-52 2007 Buell Firebolt: Electrical
SEAT.
2.25 HEAD-
BRACKET.
10720
1
1. Instrument module
2. Bulbs
3. Screwdriver
Figure 7-62. Bulb Replacement for Instrument Module
3. See Figure 7-62. Insert screwdriver blade into the slot on
the back of the bulb to be replaced and lightly turn coun-
terclockwise and remove bulb.
1
1. Light grey/taller bulb-Y0162.02A8
2. Dark grey/shorter bulb-Y0163.02A8
Figure 7-63. Instrument Module Bulbs
NOTE
See Figure 7-63. Bulbs are identified both by color and
length.
4. Select correct replacement bulb and install into back of
instrument cluster.
5. Reinstall back cover and insert and tighten the nine fas-
teners originally removed.
7.18
3
3
2