Buell 2007 FIREBOLT Service Manual page 619

HOME
14. Disconnect wiring located under sprocket cover. See
7.25 SPROCKET COVER
15. Remove connector from oil pressure switch [120]. Oil
pressure switch is located on front of engine.
16. See 2.34 INTAKE COVER
a. Intake air temperature sensor [89]
b. Throttle position sensor [88].
c. Disconnect O2 sensor {137}.
d. Disconnect temperature sensor [90].
e. Fuel injectors [84] & [85].
f. Ignition coil and remove. See
g. Fuel pump connector [86].
17. Remove fairing. See
SHIELD, AND MIRRORS.
7-64 2007 Buell Firebolt: Electrical
WIRING.
ASSEMBLY. Disconnect:
4.32 IGNITION COIL.
2.37 FRONT FAIRING, WIND-
18. Disconnect:
a. Flasher connector [30].
b. Bank angle sensor connector [134].
c. Electronic control module (ECM). See
TRONIC CONTROL
d. Instrument module connector [39].
e. Horn connectors [122].
f. Ground terminals on front of steering head.
g. Left switch housing connector [24] and right switch
housing connector [22].
h. Clutch switch [95] from left switch housing.
i. Front brake switch [121] from right switch housing.
j. Headlight connector. [38]
k. Ignition switch [33].
19. Remove fuse block and relay block by removing fasten-
ers securing them to fairing support bracket.
20. Remove fuse and relay bundle clamps.
21. Remove fuse block and relay block from their brackets.
22. Remove any remaining cable straps and clamps secur-
ing wire harness and remove harness from front of vehi-
cle.
23. Remove all tree fasteners from frame.
4.30 ELEC-
MODULE.