Voltage Regulator - Buell 2007 FIREBOLT Service Manual

HOME

VOLTAGE REGULATOR

GENERAL
The voltage regulator is mounted to the front of the crank-
case. The voltage regulator is not repairable. Replace the unit
if it fails.
REMOVAL
1. Remove seat. See 2.38 SEAT.
1 1
WARNING WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a).
2. Disconnect negative battery cable from battery.
IMPORTANT NOTE
When disconnecting the alternator stator wiring, pull
apart the connector by firmly grasping both connector
halves. Do not pull on leads or damage to the wires and/
or terminals may result.
3. See Figure 7-37. Disconnect stator connector [46] (1)
and voltage regulator connector [77] (2) located under
sprocket cover. See 7.25 SPROCKET COVER
4. Remove fasteners (5) and voltage regulator (4) from
bracket (3).
INSTALLATION
1. See Figure 7-37. Attach new voltage regulator (4) to
bracket (3). Tighten fasteners (5) to 60-72in-lbs (6.7-8
Nm).
2. Connect stator connector [46] (1) and voltage regulator
connector [77] (2) located under sprocket cover. See
7.25 SPROCKET COVER
3. Connect negative battery cable to battery terminal.
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
4. Install seat. See 2.38 SEAT.
5. Test charging system. See
7-32 2007 Buell Firebolt: Electrical
WIRING.
WIRING.
7.7 CHARGING SYSTEM.
b1095x7x
R
BK
[77]
1
2
Voltage
Regulator
Stator
Figure 7-36. Voltage Regulator Connector [77]
b1004x7ax
3
2
1
1. Stator connector [46]
2. Voltage regulator connector [77]
3. Voltage regulator mount bracket
4. Voltage regulator
5. Fastener (3)
Figure 7-37. Voltage Regulator
7.9
1
Main Fuse
2
1
2
[46]
1 1
2 2
3 3
4 4
4
5