Clutch Control; Clutch Cable - Buell 2007 FIREBOLT Service Manual

HOME

CLUTCH CONTROL

GENERAL
For clutch adjustment, see 1.9
For clutch replacement, see
REMOVAL/DISASSEMBLY

Clutch Cable

11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1. Remove seat. See 2.38
2. Disconnect negative battery cable. See
MAINTENANCE.
3. Remove chin fairing. See
10500
Figure 2-93. Clutch Cable Wire Form
4. See Figure 2-93. Remove wire form from front isolator.
NOTE
Always disconnect front tie bar from the "V" bracket first.
5. Remove front tie bar from "V" bracket.
6. Remove front tie bar, P clamp and clutch cable from
engine.
7. Remove cable strap securing clutch cable to voltage reg-
ulator wire.
CLUTCH.
6.4 CLUTCH.
WARNING
SEAT.
1.5 BATTERY
2.33 CHIN FAIRING.
1. Rubber boot
2. Cable adjuster
3. Jam nut
4. Cable end
Figure 2-94. Clutch Cable Adjuster Mechanism
8. See Figure 2-94. Slide clutch cable adjuster boot (1) up
to access clutch adjuster (2).
9. Loosen clutch adjuster (2) to release tension from hand
lever and clutch release mechanism.
10. See Figure 2-95. Remove clutch cable ferrule (7) from
hand lever (4).
NOTE
See D.1 HOSE AND WIRE ROUTING
11. Pull clutch cable down and out of upper triple clamp.
12. Remove three TORX screws with washers securing
clutch inspection cover.
13. See Figure 2-96. Remove clutch inspection cover (2).
b0939b2x
1
7
6
5
1. Hand lever clamp pinch fastener
2. Hand lever clamp
3. Hand lever pinch fastener and nut
4. Clutch hand lever
5. Clutch adjuster
6. Clutch cable adjuster boot
7. Clutch cable ferrule
Figure 2-95. Clutch Hand Control Assembly
2007 Buell Firebolt: Chassis
2.24
x0055x6x
1
2
3
4
in Appendix D.
3
2
3
4
2-67