Idle Speed Control - Buell 2007 FIREBOLT Service Manual

HOME

IDLE SPEED CONTROL

ADJUSTMENTS
NOTE
Setting the idle below the recommended speed can result in
hard starting, especially in cold ambient temperatures.
See Figure 4-28. The idle speed control cable (1) is located
on the left side of the vehicle between the front cylinder head
and the ram air scoop assembly (2). Idle speeds are listed in
4.1 SPECIFICATIONS. A 3/16 in. allen wrench may be used
to turn adjuster knob.
Table 4-14. Engine Idle Speeds
MODEL
All
NOTE
Idle adjuster is located near the engine and could be
extremely hot. Use suggested tool for adjusting the idle
speed. Failure to comply could result in minor or moderate
injury.
The idle speed should be adjusted when the engine is at nor-
mal operating temperature 320° F (160° C).
NOTE
An idle speed too low can cause poor throttle response. An
idle speed too high can cause a slow return to idle.
See 1.16 THROTTLE CABLE AND IDLE SPEED ADJUST-
MENT for more information on idle speed adjustment.
REGULAR IDLE
1050-1150
8390
1
1. Idle speed control cable
2. Ram air scoop
Figure 4-28. Idle Adjustment Cable
2007 Buell Firebolt: Fuel System
4.14
2
4-37