Buell 2007 FIREBOLT Service Manual page 142

HOME
DISASSEMBLY
Bearing Removal
NOTE
On single disc wheels, always remove the brake disc side
first.
1. See Figure 2-6. Remove wheel bearings using WHEEL
BEARING REMOVAL/INSTALLATION KIT (Part No.
B43993-50) and WHEEL BEARING REMOVER AND
INSTALLER (Part No. HD-44060).
2. Sparingly apply Extreme Pressure Lubricant (J-23444-A)
to the threads of the short forcing screw (1) to prolong
service life and ensure smooth operation.
i04277
4
3
2
1
1. Short forcing screw
2. Nut
3. Nice bearing
4. Washer
5. Bridge
Figure 2-6. Assemble Puller
3. Assemble the short forcing screw (1), nut (2), Nice bear-
ing (3), washer (4) and bridge (5) from the WHEEL
BEARING INSTALLER/REMOVER (HD-44060).
4. See Figure 2-7. Insert the FRONT WHEEL BEARING
REMOVER COLLET (B-43993-7) into the wheel bearing
until it fully seats against the bearing.
5
i04276
Figure 2-7. Install Collet and Ball Bearing
5. Insert the ball bearing into the collet.
6. See Figure 2-8. Thread the puller assembly (1) into the
collet (2).
7. Hold the collet (2), and turn the forcing screw (3) to
expand the collet.
i04278
1
1. Puller assembly
2. Collet
3. Forcing screw
Figure 2-8. Expand the Collet
8. See Figure 2-9. Place the bridge (1) against the wheel
hub.
9. Hold the forcing screw (2), and turn the nut (3) clockwise
until the bearing is free of the hub.
2007 Buell Firebolt: Chassis
Collet
Ball bearing
3
2
2-11