Buell 2007 FIREBOLT Service Manual page 100

Table of Contents

Advertisement

HOME
6.
Squeeze clutch hand lever to maximum limit three times.
This sets the ball and ramp mechanism. Pull outer cable
conduit and at the same time adjust cable adjuster to
provide 1/16-1/8 in. (1.6-3.2 mm) free play at clutch hand
lever. Adjust as follows:
a.
See
Figure 1-25.
Pull ferrule (end of cable housing)
away from bracket. Gap between ferrule and bracket
should be 1/16-1/8 in. (1.6-3.2 mm).
b.
See
Figure 1-23.
Set free play by turning adjuster
(4).
c.
Tighten jam nut (3) against adjuster (4).
d.
Slide boot (1) over cable adjuster mechanism.
7.
Change or add transmission fluid if necessary.
8.
See
Figure 1-20.
Install clutch inspection cover and new
gasket using three fasteners and washers and tighten to
84-108 in-lbs (10-12 Nm).
b0289x6x
1/16-1/8 in.
(1.6-3.2 mm)
Ferrule
Bracket
Figure 1-25. Adjusting Clutch Free Play
2007 Buell Firebolt: Maintenance
1-27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firebolt series

Table of Contents