Intake Cover Assembly - Buell 2007 FIREBOLT Service Manual

HOME

INTAKE COVER ASSEMBLY

REMOVAL
1. Remove seat. See 2.38 SEAT.
2. See Figure 2-117. Remove fasteners and nylon washers
(2).
3. Remove intake cover assembly (1).
INSTALLATION
1. Position intake cover assembly over top of air cleaner
cover.
2. See Figure 2-117. Start the front two fasteners (2) with
nylon washers.
b1222x2x
b0981x2x
2
1. Intake cover assembly
2. Intake cover fasteners and washers
3. Intake air inlet
1
Figure 2-117. Intake Cover Assembly
3. See Figure 2-117. Secure intake cover assembly (1) with
fasteners and nylon washers (2). Tighten to 12-36 in-lbs
(1.3-4 Nm).
NOTE
Front screws go in at a slight angle.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
4. Install seat. See 2.38 SEAT.
3
2007 Buell Firebolt: Chassis
2.34
WARNING
2
2-87