Buell 2007 FIREBOLT Service Manual page 621

HOME
i. Install electronic control module. See
TION under 4.30 ELECTRONIC CONTROL MOD-
ULE.
j. Bank angle sensor connector [134].
k. Flasher connector [30].
15. See Figure 7-83. Verify proper fairing wire routing and
cable strap locations.
16. Verify that front forks can be turned from full left to full
right lock without wire harness binding or pinching.
17. Install fairing. See INSTALLATION
FAIRING, WINDSHIELD, AND
18. Connect fuel pump connector [86].
19. Install fan and tighten fasteners to 12-36 in-lbs (1.4-4.1
Nm). See 4.38 COOLING
20. Install rear shock absorber assembly. See
SHOCK ABSORBER.
21. See Figure 7-78. Connect foot brake light switch connec-
tor [121] (5). Install cable strap (4).
22. Install main fuse case (3).
23. Install main battery ground (1) and wire harness ground
(2). Tighten fastener to 48-72 in-lbs (5.4-8.1 Nm).
24. See Figure 7-77. Connect tail harness connector (3).
Attach cable strap (2).
25. Connect interactive exhaust connector [165] to main har-
ness (XB12 models only).
26. Install starter side of positive battery cable and connect
starter solenoid [128] to starter.
1 1
WARNING WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
27. Install positive battery cable (red) to positive terminal of
battery. Tighten to 72-96 in-lbs (8-11 Nm).
28. Connect negative battery cable. Tighten to 72-96 in-lbs
(8-11 Nm).
29. Install tail frame upper body work. See
TAIL ASSEMBLY AND BODY
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
30. Install seat. See 2.38 SEAT.
7-66 2007 Buell Firebolt: Electrical
INSTALLA-
under 2.37 FRONT
MIRRORS.
FAN.
2.22 REAR
2.36 SUBFRAME
WORK.
12012
1
1. Middle cable strap
2. Front cable strap
Figure 7-81. Cable Straps (Typical)
8829
1
2
1. Fuse block
2. Clamp
3. Bottom fuse block fastener
4. Top fuse block fastener
Figure 7-82. Fuse Block
2
4
3