Main Wire Harness - Buell 2007 FIREBOLT Service Manual

HOME

MAIN WIRE HARNESS

GENERAL
The main wire harness runs from the front of the motorcycle
to the tail section where it connects to the tail section mini-
harness.
Always replace plastic tree fasteners when replacing main
wire harness. Remove tree fasteners carefully, do not leave
any fasteners in frame.
REMOVAL
NOTES
To ensure correct installation, make note of wire routing
and cable strap locations before removing main wire har-
ness.
Main wire harness is removed from front of vehicle in
between fork tube and frame.
1. Remove seat. See 2.38
1 1
WARNING WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
2. Unthread fastener and remove battery negative cable
(black) from battery negative (-) terminal.
3. Pull back terminal cover boot.
4. Unthread fastener and remove battery positive cable
(red) from battery positive (+) terminal.
5. Disconnect positive battery cable and solenoid connec-
tor [128] from starter.
6. Remove tail frame upper body work.
TAIL ASSEMBLY AND BODY
7. See Figure 7-77. Disconnect tail harness connector [7]
(3).
8. See Figure 7-78. Remove wire harness ground (2).
9. Remove main fuse case (3).
10. Disconnect interactive exhaust connector [165B] from
main harness (XB12 models only).
11. Disconnect foot brake light switch connector [121] (5).
12. Remove the rear shock absorber assembly and reser-
voir. See 2.22 REAR SHOCK
13. Remove fan. See 4.38 COOLING
SEAT.
2.36 SUBFRAME
WORK.
ABSORBER.
FAN.
8463
2
1
1. Main wire harness
2. Cable strap
3. Tail harness connector [7]
Figure 7-77. Tail Harness Connector
8478
1
2
3
4
5
1. Main battery ground
2. Wire harness ground
3. Main fuse case
4. Cable strap
5. Foot brake light switch connector [121]
Figure 7-78. Battery Tray Wiring
2007 Buell Firebolt: Electrical
7.23
3
7-63