Buell 2007 FIREBOLT Service Manual page 326

HOME
b1016x3x
PISTON JETS
Removal
b1113x3x
Figure 3-135. Piston Oil Jet Assemblies
1. See Figure 3-135. Remove two TORX screws from each
piston jet assembly to free piston jets from right crank-
case.
2. Remove piston jet gaskets from right crankcase.
D
Indicates Bolt Pattern Location
Figure 3-134. Crankcase Fasteners
One Behind Shifter Mechanism
Installation
NOTES
Gaskets that are missing, distorted, pinched or otherwise
damaged will result in either oil leakage or low oil pres-
sure.
Gasket is part of the piston jet assembly. Gasket not sold
separately.
1. Install new piston oil jet assemblies in right crankcase.
2. Apply LOCTITE Low Strength Threadlocker 222 (purple)
to threads of TORX screws.
3. With the jet pointed upward, install TORX screws to
secure piston jet to crankcase. Tighten screws to 25-35
in-lbs (2.8-4.0 Nm).
Removing Cylinder Base Studs
If cylinder base studs require replacement, proceed as fol-
lows.
1. Thread a 3/8"-16 nut onto cylinder base stud.
2. Thread a second nut onto stud until it contacts the first
nut.
3. Tighten nuts against each other.
4. Placing wrench on first (lower) nut installed, unscrew
stud from cylinder deck.
5. Loosen nuts and remove from cylinder base stud.
2007 Buell Firebolt: Engine 3-95