Changing Lanesense Status; Parkview Rear Back Up Camera - Dodge CHARGER 2021 Owner's Manual

126 STARTING AND OPERATING
When the LaneSense system senses the lane

has been approached and is in a lane depar-
ture situation, the left lane line flashes yellow
(on/off). The LaneSense telltale changes
from solid yellow to flashing yellow. At this
time torque is applied to the steering wheel in
the opposite direction of the lane boundary.
For example, if approaching the left side of
the lane the steering wheel will turn to the
right.
Lane Approached With Flashing Yellow Line/Flashing
Yellow Telltale
NOTE:
The LaneSense system operates with similar
behavior for a right lane departure.
C L S S
HANGING ANE ENSE TATUS
The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (early/med/late) that
you can configure through the Uconnect system
Ú page 140.
NOTE:
When enabled the system operates

above 37 mph (60 km/h) and below
112 mph (180 km/h).
The warnings are disabled with the use of the

turn signal.
The system will not apply torque to the

steering wheel whenever a safety system
engages (Anti-Lock Brakes, Traction Control
System, Electronic Stability Control, Forward
Collision Warning, etc.).

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear
surroundings of your vehicle whenever the gear
selector is put into REVERSE.
The image will be displayed on the Navigation/
Multimedia radio display screen along with a
caution note to "Check Entire Surroundings"
across the top of the screen. After five seconds
this note will disappear. The ParkView Rear
Back Up Camera is located on the rear of the
vehicle above the rear license plate.
Manual Activation Of The Rear View Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may be
selected through the Uconnect system
Ú page 140.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen
appears. When the vehicle is shifted out of
REVERSE (with camera delay turned on), the
camera image will continue to be displayed for
up to 10 seconds unless the following
conditions occur: