Changing Lanesense Status; Parkview Rear Back Up Camera - Dodge DURANGO 2021 Owner's Manual

C L S S
HANGING ANE ENSE TATUS
The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (early/late) that you
can configure through the Uconnect system
Ú page 175.
NOTE:
When enabled the system operates above

37 mph (60 km/h) and below 112 mph
(180 km/h).
The warnings are disabled with use of the

turn signal.
The system will not apply torque to the

steering wheel whenever a safety system
engages (Anti-Lock Brakes, Traction Control
System, Electronic Stability Control, Forward
Collision Warning, etc.).

PARKVIEW REAR BACK UP CAMERA

Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put
into REVERSE. The image will be displayed on
the Navigation/Multimedia radio display screen
along with a caution note to "Check Entire
Surroundings" across the top of the screen.
After five seconds this note will disappear.
The ParkView camera is located on the rear of
the vehicle above the rear license plate.
When the vehicle is shifted out of REVERSE (with
camera delay turned off), the rear camera mode
is exited and the previous screen appears.
Manual Activation Of The Backup Camera
1. Press the "Vehicle Menu" button located at
the bottom of the Uconnect display. Then
select the "Controls" tab.
2. Press the "Rear View Camera" button to
turn the Rear View Camera system on.
STARTING AND OPERATING
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may
be selected through the Uconnect system
Ú page 175. In certain radio configurations,
these modes of operation will be found in the
"Camera" section of the vehicle settings menu.
When the vehicle is shifted out of REVERSE (with
camera delay turned off), the rear camera mode
is exited and the previous screen appears. When
the vehicle is shifted out of REVERSE (with
camera delay turned on), the camera image will
continue to be displayed for up to 10 seconds
after shifting out of REVERSE unless the following
conditions occur: the vehicle speed exceeds
8 mph (13 km/h), the vehicle is shifted into
PARK, the vehicle's ignition is placed in the OFF
position, or the touchscreen button "X" to disable
the display of the Rear View Camera is pressed.
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/
receiver. Different colored zones indicate the
distance to the rear of the vehicle.
151
4